INCL NAPPA REINS
The noseband can be worn as either a cavesson or hanoverian, with the flash easily removable. Featuring a non-crank closure, the noseband distributes pressure evenly and provides a perfect fit.
This bridle comes with an elegant, deep drop blue toned browband and stainless steel fittings.
Features:
- Black vegetable tanned premium leather
- Elegant deep drop blue, clear and black crystal browband
- Gel-padded anatomic head piece (single strap)
- Gel-padded convertible noseband - can be worn as a cavesson or hanoverian
- Stainless steel fittings
- Quality stitching and craftsmanship
Not sure about size?
How do you measure a standard bridle?
Browband: measured from the end of each loop, straight across. Even if the style is curved.
Noseband: measured as a circumference when done up in the middle hole
Headpiece: measured with the cheek pieces attached on the middle hole. Measure from bit, to bit, over the top of the horse's head.
Reins: measured as a single side length from bit to buckle (don't measure the buckle).
Standard bridle sizing chart:
How do you measure an anatomic / micklem style bridle?
To get the perfect fit for your anatomic / micklem style bridle, refer to the below sizing chart, using the diagram. It is recommended that you mark out the measurements with chalk on your horse’s face, so that once you’ve finished your measurements you can see the pattern of the fit, and be sure you have measured correctly.
Our micklem style bridles are fairly standard in sizing.
Measurement 1: measure from 1cm under the horse's cheekbone, all the way over the horse’s poll to the same point on the other side.
Measurement 2: measure the browband vertically from end of loop, to end of loop (don’t dip the measuring tape for curved browbands).
Measurement 3: run your finger down the bottom point of the protruding cheek bone until you get to the top of the bit. Then measure across your horse’s nose horizontally to the same point on the other side.
Measurement 4: from the outer corner of your horse’s eye, run your finger vertically down your horse’s face and stop when you reach around the middle of the bit ring (you will be an inch or so away from the bit ring). Measure from this point under your horse’s chin to the same point on the other side of its face.
Anatomic / micklem style bridle sizing chart:
Measurements are taken from the middle hole, with 2-3 holes available either side. Therefore you are looking for the sizing that is closest to your measurements – not exactly the same as your measurements.
